Setup & supportResidents in and out4.08
A new resident
Add someone who's moving in, and record their consent.
Add them
On the Residents page in the web app:
- 1Click the empty bed.
- 2Click Move resident into bed.
- 3Enter their name and check the move-in date.
- 4Click Continue, then Submit.
A bed shows as empty when its sensor is turned off because the room is unoccupied, or the resident is in hospital or on leave. The move-in date is Today unless you change it. Adding a new resident resets the bed's graphs, saved falls, risk settings and everything else stored for it, so check the room before you click Submit.
If someone else is still in the bed, open it, then Bed settings and Add new resident. You'll be asked why the previous resident is moving out. If the sensor is still off once they've moved in, turn it on in Bed settings too.
To get ready before someone arrives, open Department, then Residents, and use Move-ins. You can add them with Add upcoming resident and confirm their room on the day.
Record consent
In the web app:
- 1Open Department, then Residents.
- 2Click Settings next to the resident.
- 3Tick a contact, then Send consent.
- 4Or upload a signed copy.
This is fine-tuning consent. With it, short clips from moments when Teton is unsure, makes a mistake or sees a safety event may be shared with Teton to make detection more accurate for that resident. Without it, no training data is collected from the room, and Teton still works in full.
Send consent sends a form to sign to the contacts you've ticked. Add them first with Add contact, under Family and care contacts. For a paper form, click Browse files and upload the signed PDF. The resident's row shows whether they've Consented.
Good to know
- Check the room number before you add a resident. Adding them resets that bed's history.
- Learn more about training data, in the resident's settings, explains what's shared with Teton.